WSPR Beacon Ideas for UHF

This is an early design sketch of a UHF (70cm - 440 MHz) WSPR beacon. This design comes from Ismo (OH2FTG). Key Points 10 MHz OCXO TCXO powering the Si5351 module instead of the usual 25 or 26 MHz 0.5 ppm TCXO. Si5351 generates 217 MHz output, which we double to ~434Mhz using the https://techlib.com/files/diodedbl.pdf technique. Use 440 MHz SAW filter at the output (from LCSC) ONSEMI MMBD701LT1G RF Schottky diodes - locally available Modulation is continuous phase 4-FSK, with 1.4648 Hz tone separation. Since tone separation will also double with the above circuit, we have to make appropriate changes in the base stage (Si5351). INNOTION YG602020 gain block into ATTN and then into INNOTION YG401530VB driver block. Use Mitsubishi RD15HVF1-501 MOSFET as finals Easy and more than 1W RF output? ...

July 3, 2026 · 1 min · 141 words · Dhiru Kholia

433 MHz CW signal source

For HF and amateur VHF bands our WiFi VFO works great. But we didn't have a cost-effective UHF signal source until now… Design Thanks to Ismo (OH2FTG), we recently experimented with a HopeRF CMT2119A powered board called HOPERF RF module RFM119W-433S1. Here is the CMT2119A powered board in action producing a CW (OOK) signal at ~433 MHz. The stability is pretty good and a bit surprising considering that the board uses a 20ppm 26 MHz regular quartz crystal - not bad! ...

October 4, 2025 · 8 min · 1642 words · Dhiru Kholia