Ismo

Idea Ismo recently shared the https://github.com/CoolNamesAllTaken/adsbee project which is pretty cool. Challenges The ADS-B (Automatic Dependent Surveillance-Broadcast) system uses a data rate of 1 Mbit/s (1 megabit per second) for its aircraft position and identification transmissions on the 1090 MHz frequency. This is too much for HOPERF CMT2300A and related transceiver chips unfortunately! This got us thinking about the following VFM ADS-B RX chain. Architecture Here is a simple ADS-B RX circuit description. ...

Ismo (OH2FTG) has praised the STM32's ADC quality multiple times, and I finally decided to give it a go. I usually stick with Waveshare RP2350-Zero boards, but the RP2350 ADC performance is limited to under 10 ENOB. With the STM32H562RGT6, we're able to achieve ~13 ENOB using 16× hardware ADC oversampling, with potential headroom to push this even further. By sampling the Si4732's SSB output using the STM32H562RGT6 ADC and exposing the audio samples to the host via a "virtual" USB UAC-2 device, we get the following RX results: ...

Note: This HF LNA design is inspired by PY2OHH designs and mcHF work. Previous article: Single Transistor LNA for HF - it cut a corner when it came to output impedance matching ;) Design The idea that a single-transistor-preamp with 10 dB gain is more than enough for HF comes from Gajendra Kumar (VU2BGS). As a new "designer" I am often overwhelmed by the different possible design paths - so having guidance from an elmer becomes crucial. ...

Future radio receiver design ideas (from Ismo, Pete and other folks): Antenna ➔ (BPF) ➔ BFR93A based pre-amp from mcHF project ➔ MC1496 (Mixer) ➔ 455 kHz IF ➔ Ceramic filter SMD (HCI) ➔ 'IF amplifier' (20-40 dB gain?) ➔ Overclocked Pico 2's ADC (3+ MSPS) ➔ Digital down-conversion and processing in digital domain ➔ Expose the processed audio samples over USB (Pico 2 acts as a sound card). Benefits: This enables reception of SSB and CW signals! The 455 kHz IF with digital processing gives us the best of both analog selectivity (ceramic filter) and digital flexibility. ...

Shipping hardware internationally is a hard, labor intensive, and overall a frustrating process - especially more so these days. Here is our plan to supply the DDX to customers: Make the hardware files free / low-cost. The users will be able to order fully assembled boards from JLCPCB or other vendors on their own. Required a small licensing fee for the software firmware part. This is how we get to keep the hobby self-sustaining! ...