RF Hacking

My homebrewed PA0FRI Active Antenna is working well from a very physically constrained location. Design 3D render: Schematic: Results The antenna is connected to an RSP1 Clone SDR running custom FT8 band-hopping software. I am using a SOLID 4-Way 5-2400 MHz RF splitter to connect multiple SDRs to the same active antenna. NB: Plug in 75-ohm dummy loads (terminators) on the unused splitter ports; MX-282 / MX-280 75-ohm loads work fine. ...

Sometimes we all need a bit of QRO - Life's too short for QRP sometimes. So we give you the Baby-QRO switching amplifier! This Baby-QRO switching RF amplifier design is inspired by the wonderful Single NXP MRF-101 Eval Board project by Jim Veatch. Thank you Jim! Instead of using the expensive MRF101 MOSFET, we use fast SiC MOSFET(s) from Wolfspeed / SUPSiC. Design 3D render: Actual picture: ...